使用iLogic改变草绘中的尺寸

It is a bit tricky but you can add a new rule and inside that rule set the named dimensions and parameters.

Inside a part add a rule. Here is an example, Blue words are parameters/dimensions from the part or sketch, so this block uses the two objects (DiamColl and DiamAtt) to change a diameter called Dcoll .

1. Dim RagColl as Double
   
2. Dim RagAtt As Double
   
3. 
   
4. RagColl = DiamColl/2.0
   
5. RagAtt = DiamAtt/2.0
   
6. 
   
7. If RagAtt < RagColl Then
   
8. Dcoll = Sqrt((RagColl*RagColl) - (RagAtt*RagAtt))
   
9. Else
   
10. Dcoll = 0.0
    
11. End If

复制代码

What is also a bit tricky is when things get triggered.